Eberspacher easy start select for airtronic and hydronic heaters. Also suitable for latest generation s2 d2l heaters important information this is only compatible with airtronic and hydronic heaters fitted with the latest version control unit. These are identified by the h-kit logo displayed on the heater dataplate as shown in image 2 above. Continuous running is only achievable with airtronic heater models. The eberspacher easystart select has a maximum run time of 1hr on hydronic models. Please also view 'workshop menu' image for additional heater diagnostics and controller settings. The new eberspacher easystart select is a temperature controller suitable for both eberspacher airtronic air & hydronic water heaters. Genuine eberspacher easystart select product suitable for both 12 volt or 24 volt installations comfortable room temperature control, heating & vent modes surface mountable for ease of installation technical support and additional products available from butler technik workshop menu to enter in the workshop menu press simultaneously the buttons for 5 seconds. Then navigate in the menu where items are labelled from 1.1 To 6.4. Fault codes retrieval heater must be switched on 1.1: Displays the current fault code 1.2: Displays the five last fault codes recorded
F1 to f5 using buttons setting the operating time 4.1: Before switching on the heater, select the value with off or 10 to 720 min dimensions: width:55 mm height:46 mm depth: 9mm supplied with the follo...
Brand: Eberspacher
